Hooke Road® Rear Inner Fender Liners Black Steel(07-18 Jeep Wrangler JK)

2018 JKU. Start with the bottom right bolt. You will need a wrench (crescent/open side) to hand tighten. Next connect the top right bolt. Tighten to leave just enough give as you need a bit of wiggle room but you most likely will not be able to tighten it later. Finally you will need a crow bar/wonder bar to pry up the bottom left side so the holes line up. You will definitely need a 2nd person to either hold the bar or put the bolt/nut on. Tighten everything. There is no possible way you are connecting the top left bolt so just come to terms with that or this is not the product for you. Also you will probably never get this out so be sure it's the look you are going for.

These inner fenders give the Jeep a nice look but installation makes you wonder if it was worth buying it. These comes with installation directions that are not the best to follow. The front ones were not bad to install then you go on to install the rear ones and good luck. The alignment does not work on all holes and it is almost impossible to hold the washer and the nuts while trying to put the bolts. Due to the unclear directions and difficulty to install these I am only rating them a 3 out of 5.

I love the look of these inner rear fenders. Installation was fairly easy on the driver side. However the passenger side was a pain. The holes at the top of the fenders just did not line up and the rear corner kept popping out when tightened. As long as you know how to adjust and improvise. You should be fine. Installation took me about 3 hours.

I ordered these after buying and installing Hooke Road “Since 1941” front fender liners which are aesthetically pleasing and functional.

Installation for the rear liners turned out to be more challenging (2.5 hrs) than the front (1.5 hrs). Some modification was necessary to properly secure them.

The challenge (slight) was fun. The outcome is also very pleasing.

I love the look and have both front inner fenders on my 2013 Jeep Rubicon. Price was fair, look is great. But install was no walk in the park. I have read a few other reviews and they have it right. It takes 4 to 5 hours to do the front and back. I did mine alone, would suggest you have a friend help you. The rear passanger side I had problems lineing up the bolt holes and closing the gap to get the provided bolts to thread as they were a bit too short to reach. Only had this problem on the passangerside rear. After a few hours of struggle went and bought a longer bolts about 3/8 longer and I was able to pull it into place. It took a lot longer than I planned, but I do like the look and like they are one peice, that is why I gave it 4 stars. Would recommend to a friend and even help them do the install.