Grille Guard Front Bumper w/ Winch Plate (90-95 Toyota 4Runner) - Hooke Road

Features

• Compatible with 1990-1995 Toyota 4Runner Models
• Features high strength D-ring mounts. D-rings not included
• Equipped with a flip-up license plate mount
• Equipped with a silver stainless steel skid plate
• Equipped with 2 LED amber turn signal lights
• Comes with a winch plate up to 12,000 lbs
• 2×25W LED spotlights included. Wiring harness is not included. 18-gauge wire is required for a safe connection.
• Bumper weight: about 122 lbs
• Heavy-duty, high tensile 11-gauge (1/8 in) steel for bumper main body, 9-gauge(5/32 in) steel for mounting structure and winch plate, 14-gauge(5/64 inch) stainless steel plate for skid plate, 1.89"×0.06" steel tube construction
• Textured black powder coat finish & Premium E-coating process inside
• Direct bolt-on installation

Details

Design and Utility. A full grille guard gives the front bumper added front-end coverage and a bold, trail-ready appearance. It features 2×25W LED spotlights for extra illumination, along with two amber LED turn signal lights to improve visibility and signaling. High-strength D-ring mounts provide recovery attachment points, while the winch plate accommodates winches rated up to 12,000 lbs. A license plate mount and silver stainless steel skid plate complete the setup, combining practical functionality with a distinctive off-road look.

Heavy Duty Construction. The bumper main body is made from heavy-duty, high-tensile 11-gauge (1/8 in) steel, complemented by 1.89" × 0.06" steel tubing for the grille guard. The mounting structure and winch plate use 9-gauge (5/32 in) steel for added strength, while the skid plate is constructed from 14-gauge (5/64 in) stainless steel. A textured black powder coat finish gives the bumper a rugged exterior, and the Premium E-coating process inside provides additional corrosion protection.

Direct Bolt-on Installation. The bumper uses the vehicle’s factory mounting points for a straightforward bolt-on installation. Remove the factory bumper first, then position the new bumper and secure it with the supplied hardware. No cutting, drilling, or permanent vehicle modifications are required. Follow the included instructions, check the bumper’s alignment before fully tightening all fasteners. Due to the bumper’s heavy weight, assistance or suitable lifting equipment is recommended.